Troubles And Solution - Oceanic OCEACLIM100W1 Guide D'utilisation

Some malfunctions can be easily solved. Before calling for service or a repairer, please
refer to the following table:
Problems
- Check that the device is
- Check if the power cord or plug
- Check if the fuse is not
The device does
not work.
- When using the remote control,
- The device has entered security
- The circuit breaker has been
The unit does not
work and the
- The water tank is full
ALARM indicator
is lit
- Check if the air outlet is not
The device runs
for a short time
and stops - The timer has been activated
automatically
- Temperature setpoint close to
VII. TROUBLES AND SOLUTION
Possible causes
connected properly.
is not damaged.
damaged.
check that the batteries are not
discharged.
mode
tripped
obstructed
room temperature
- Connect the device;
- Call an electrician for replacement.
- Contact your service department or
an electrician for replacement (For
details on the fuse, please refer to II.
- Replace the batteries of the remote
control
- Wait 3 minutes before pressing the
On / Off button.
- Check the state of the circuit breaker
- Drain the condensate using the drain
hose at the rear of the unit.
If the problem persists, contact the
service center or a qualified
technician.
- Remove the obstacle.
- Switch on your device and set the
timer.
- Lower the temperature setpoint.
63
Solutions