Valor 2200SFK Guide D'installation Et D'operation page 5

b) Assemble the two side panels to the bottom
frame (9 screws per side). The side panels
are identical. The cutout in each panel is a
potential location for the Remote Battery &
Wall Switch Kit box. Note that this cutout is
closer to the bottom edge.
c) Assemble the top frame to the two side
section (9 screws per side). The wider part
goes to the rear.
d) Assemble the two front vertical studs to the
front of the section.
Note: The studs may be installed
later to allow additional access
space to mount venting and
HeatShift systems.
e) A 2" x 4" x 50" long wood stud nested into the
upper frame will help stiff en the assembly
when attaching the section to the wall behind
the appliance.
2" x 4" x 50" long
(not supplied)
5