Valor 2200SFK Guide D'installation Et D'operation page 4

Installation
Base Section (optional)
1. Place base section in position with the 2" stand-off s
against the rear wall.
2. Place LX2 appliance on top of base section keeping
a 2" clearance from the rear wall.
3. Fold down fi xing tabs at the base of the appliance
and screw to the base.
Middle Section
4. The middle section comes fl at-packed and must be
assembled before fi tting it on top of the fi replace.
All 52 screws must be inserted from the outside
so they don't interfere with the wall fi nish installed
later.
a) Identify all the pieces and orientation of
the section.The bottom and top frames are
identical. The wider part is at the rear. The left
and right panels are also identical.
4
Fold down flat against
base section and screw
appliance to base
Rough-in gas and
electrical prior
V-shaped feet (3)
recess within base
section when installed
Left side panel
(identical to right)
Note:
cutout is closer
to bottom edge
Vertical studs (2)
Fasten to floor
through here after
final positioning
2" from
wall
Top panel
(identical to
bottom panel)
Right side panel
(identical to left)
Note:
cutout is closer
to bottom edge
Bottom panel
(identical to
top panel)