Oceanic OCEACLIM700W1 Guide D'utilisation page 36

HOW TO USE THE APPLIANCE
A. Use of the control panel
Putting on the appliance and mode choice: To put the
1.
appliance into operation, connect the electrical cable to a
wall outlet. The appliance will then emit a beep sound.
Press on the button
another deep sound will be emited, then pres the button
to choose your operation mode from the available
ones:
Automatic mode
Fan mode
A touch on the button
mode to another.
2. Setting of the temperature: The temperature can be
adjusted, each time by 1°C by pressing the
button, to go between the range of 15°C to 31°C.
Press the or
the temperature by 1°C. The LED display shows the set
temperature for 5 seconds, then displays the room
temperature.
3. Setting the speed of the fan: Press the button
select the fan speed from the available (slow or fast)
4. Activitating the sleep function: When you press the
button again, the device beeps and turns off.
B. Operation principles of each mode
Automatic mode
1.
selected, the temperature sensor automatically operates
and selects the operation mode Cool
depending on the room temperature.
If the room temperature is the same as or above 24℃,
the appliance will run in Cool mode
If the room temperatrue is under24℃, the appliance
will run in Fan mode
Cool mode
2. : When the room temperature is higher
than the set temperature, the compressor will start to run.
When the room temperatrue is lower than the set
temperature, the compressor will stop.
Fan mode
3. :In this operation mode, the selection of
temperature is disabled. The fan functions at the preset
temperature. The compressor will not function.
to turn on the device, which
Cool mode
Dehumidifier mode
allows you to change from one
button to increase or decrease
: When the Automatic mode is
or Fan
.
.
Dehumidifier mode
4.
for 8 minutes then stop for 6 minutes. They will resume
functioning automatically afterwards and repeat the
cycle.
Remarks:
The fan above will work at a slow speed in
Dehumidifier mode (slow by default). Fast speed are not
supported in this mode.
The setting of temperature is not supported in this
operation mode.
Sleep function
5.
Sleep function only when it is Cool mode
button
function in slow speed. The set temperature will
increase by 1℃ after one hour of functioning, by 2℃
after two hours. After six hours, the appliance stops.
Remarks:
The main control board has a memory function.
The main control board records the previous operation
or
mode before the appliance is put to Sleep function.
Consequently, as you restart the appliance, it will work
in the previous operation mode. It needs not to be
reprogrammed. This function is not available if the
previous operation mode is
The air conditioner should be used, while under
to
COOL mode or DEHUMIDIFER function, in locations
where windows are closed. Otherwise the water tank
will fill up quickly.
Timer
6.
hours. Press the button
decrease the duration. Each press increases or
decreases the time by one hour.
- Automatic OFF: when the appliance is running,
press the
which the appliance will be switched off. Allow the
number of hours on the LED flashes for a few seconds
until the timer indicator light on the left illuminates.
Afterwards, the LED will resume displaying the set
temperature.
Automatic ON: when the appliance is connected to
-
electricity but not turned on, press the button
the desired duration after which the appliance will be
turned on. Allow the number of hours on the LED
flashes for a few seconds until the LED goes off, and the
timer indicator light on the left remains illuminating.
EN-14
: the compressor will work
: The appliance can be put to
to activate this function. The upper fan will
.
: The timer can be set between 1 to 24
or
button and set the desired duration after
. Press the
to increase or
, set