Stihl MS 192 T Notice D'emploi page 8

English
Your power tool produces
toxic exhaust fumes as
soon as the engine is
running. These fumes
may be colorless and
odorless and contain
unburned hydrocarbons
and benzol. Never run
the engine indoors or in
poorly ventilated loca-
tions, even if your model
is equipped with a cata-
lytic converter.
To reduce the risk of serious or fatal
injury from breathing toxic fumes,
ensure proper ventilation when working
in trenches, hollows or other confined
locations.
To reduce the risk of accidents, stop
work immediately in the event of
nausea, headache, visual disturbances
(e.g. reduced field of vision), problems
with hearing, dizziness, deterioration in
ability to concentrate. Apart from other
possibilities, these symptoms may be
caused by an excessively high
concentration of exhaust gases in the
work area.
The dusts (e.g. sawdust), vapor and
smoke produced during operation may
be dangerous to health. If dust levels are
very high, wear a suitable respirator.
6
All manuals and user guides at all-guides.com
Check the saw chain at regular short
intervals during operation or
immediately if there is a noticeable
change in cutting behavior:
Shut off the engine and wait until the
–
chain comes to a complete
standstill.
Check condition and proper
–
mounting.
Check sharpness.
–
Do not touch the chain while the engine
is running. If the chain becomes jammed
by an obstruction, switch off the engine
immediately before attempting to
remove the obstruction – risk of injury.
To reduce the risk of injury, shut off the
engine before changing the saw chain.
To reduce the risk of fire, do not smoke
while operating or standing near your
power tool. Note that combustible fuel
vapor may escape from the fuel system.
If your power tool is subjected to
unusually high loads for which it was not
designed (e.g. heavy impact or a fall),
always check that it is in good condition
before continuing work – see also
"Before Starting". Check the fuel system
in particular for leaks and make sure the
safety devices are working properly. Do
not continue operating your power tool if
it is damaged. In case of doubt, have the
unit checked by your servicing dealer.
Make sure the idle speed setting is
correct. The chain must not run when
the engine is idling with the throttle
trigger released. Check and correct the
idle speed setting at regular intervals. If
the saw chain still moves, have your
dealer check your machine and make
proper adjustments or repairs.
Holding and Controlling the Power Tool
H
L
To reduce the risk of
accidents and injuries,
always hold your saw
firmly with both hands:
Right hand on the control
handle, even if you are
left-handed. To ensure
safe control, wrap your
fingers tightly around
both handles.
Make sure you always have good
balance and secure footing. To avoid
slipping, take special care when the bark
is wet.
One-handed operation is
particularly dangerous,
e.g. when cutting dry,
knotty and dead wood,
the chain may not enter
the cut properly. The
resultant reactive forces
may cause the saw to
skate or bounce on the
limb and slide out of
control. This increases
the risk of serious or even
fatal injury.
MS 192 T, MS 192 TC