Stihl MS 192 T Notice D'emploi page 32

English
Replacing the starter rope
Models without ElastoStart and models
with ErgoStart
Use a screwdriver to pry the rope
N
out of the starter grip.
Remove the remaining rope from
N
the rotor and starter grip.
Thread the new rope through the
N
starter grip and tie one of the special
knots shown.
Pull the knot back into the grip.
N
30
All manuals and user guides at all-guides.com
5
Thread the rope through the top of
N
the guide bushing (5).
Thread the rope through the rotor
N
and secure it with a simple
overhand knot.
Coat rope rotor bearing bore with
N
non-resinous oil.
Slip the rotor (6) with carrier (7) over
N
the starter post – turn it back and
forth to engage the anchor loop of
the rewind spring.
The spring under the carrier must
N
engages the rope rotor and the
carrier (arrows).
Fit the pawls (4) in the rotor and fit
N
the washer (3) on the starter post.
Use a screwdriver or suitable pliers
N
to install the spring clip (2) on starter
post and engage it on the pawls'
pegs – the spring clip must point
clockwise as shown in the
7
illustration.
4
4
MS 192 T, MS 192 TC