Fitting Instructions - R&G RGH0001BK Instructions De Montage

FITTING INSTRUCTIONS

If a centre stand is fitted, continue with wheel removal as described below. If a centre stand is not fitted,
we recommend fitting by a qualified motorcycle mechanic.

Lift motorcycle onto centre stand.

Remove exhaust mounting bolt from rear pillion foot rest in position shown below left.

Slacken the exhaust band bolt in position shown above right.

Support the exhaust and gently ease exhaust away from wheel until stopper contacts the frame.

Remove the wheel nuts.

Gently ease wheel out between exhaust and wheel nut studs.

Remove the two plastic grommets from holes in position shown above left.

Remove original bolt from position shown above right.

Place spacer from kit (S0380) into recess in position shown above right.

Place the washers onto the two silver button headed bolts.

Unpeel 3-4mm of the double-sided adhesive tape, leave tab for ease of removal.
Continued overleaf.....
Unit 1, Shelley's Lane, East Worldham, Alton, Hampshire, GU34 3AQ
Tel: +44 (0)1420 89007 Fax: +44 (0)1420 87301

19mm SOCKET AND WRENCH.

TORQUE WRENCH (108Nm AND 17Nm).

12mm SOCKET AND WRENCH.

12mm A/F SPANNER.
R&G Racing
www.rg-racing.com Email: info@rg-racing.com