R&G RGH0004BK Instructions De Montage

Les langues disponibles

Télécharger ce manuel

FITTING INSTRUCTIONS FOR RGH0004BK REAR HUGGER

Page | 1

THIS KIT CONTAINS THE ITEMS PICTURED AND LABELLED BELOW.

DO NOT PROCEED UNTIL YOU ARE SURE ALL PARTS ARE PRESENT.

Please note that the way the kit is packed does not necessarily represent the way of

Kit Contents:

1 x HUG0004 HUGGER

1 x S0456 SPACER LHS

1 x P-CLIP CABLE CLIP/TIDY

1 x M6x12mm LONG BUTTON HEAD BOLT

1 x M6x15mm LONG BUTTON HEAD BOLT

1 x M6x20mm LONG BUTTON HEAD BOLT

1 x M6 WASHER 12mm O/DIA

2 x M6 PENNY WASHERS 20mm O/DIA

1 x R&G LARGE BUBBLE STICKER

3 x VELCRO PATCHES

Tel: +44 (0)1420 89007 Fax: +44 (0)1420 87301

KAWASAKI Z750R 2011

mounting to the bike

TOOLS REQUIRED



10mm SOCKET AND WRENCH.

Unit 1, Shelley's Lane, East Worldham, Alton, Hampshire, GU34 3AQ

4mm ALLEN KEY.

5mm ALLEN KEY.

R&G Racing

www.rg-racing.com

Email:

info@rg-racing.com

Page 1 FITTING INSTRUCTIONS FOR RGH0004BK REAR HUGGER KAWASAKI Z750R 2011 Page | 1 THIS KIT CONTAINS THE ITEMS PICTURED AND LABELLED BELOW. DO NOT PROCEED UNTIL YOU ARE SURE ALL PARTS ARE PRESENT. Please note that the way the kit is packed does not necessarily represent the way of...
Page 2  PHILLIPS DRIVER. Page | 2 PICTURE 1 PICTURE 2 PICTURE 3 FITTING INSTRUCTIONS  UNCLIP AND REMOVE THE SPRING CLIP SHOWN IN PICTURE 1.  UNDO AND REMOVE THE THREE BOLTS ARROWED IN PICTURE 2.  REMOVE CHAIN GUARD. ...
Page 3  REUSE THE ORIGINAL BOLT TO SECURE THE REARMOST MOUNTING OF THE CHAINGUARD (ARROWED C IN PICTURE 2).  PLACE THE SMALL SPACER FROM KIT BETWEEN THE CHAINGUARD AND HUGGER IN THE POSITION ARROWED B IN PICTURE 2 AND SECURE USING THE LONGER BUTTON HEADED BOLT AND ONE OF LARGER WASHERS;...
Page 4 FRANCE INSTRUCTIONS DE MONTAGE DU RAZ DE ROUE RGH0004BK KAWASAKI Z750R 2011 Page | 4 VEUILLEZ VERIFIER QUE TOUTES LES PIECES SONT PRESENTES DANS LE KIT AVANT DE COMMENCER LE MONTAGE. Ce Kit contient : 1 x Raz de roue HUG0004...
Page 5: Important
Page | 5  Fixer la protection de chaine d’origine sur le raz de roue. Remettre le clip de ressort comme à l’origine. (photo 1)  Glisser la rondelle la plus petite sur la vis la plus petite et passer le tout à travers le P-clip (livré dans le kit), utiliser les 3 éléments pour fixer la fixation droite du raz de roue.