Assembling The Lawn Mower; Attaching The Handlebar; Assembling The Grass Catcher Box - Stihl RM 443 Notice D'emploi

English
► Make sure that the following components are
in safe condition:
– Lawn mower,
– Blade, 4.6.2.
► Clean the lawn mower,
► Check the blade,
► Attach the handlebar,
► Add engine oil,
6.3.
► Fold up the handlebar,
► Refuel the lawn mower,
► If mowing and the mown grass is to be collec‐
ted in the grass catcher box: attach the grass
catcher box, 6.2.2.
► If mowing and the mown grass is to be ejected
to the rear: detach the grass catcher box,
6.2.3.
► Set the cutting height,
► Check the controls,
► If the steps cannot be performed: do not use
the lawn mower and consult a STIHL special‐
ist dealer.
6 Assembling the Lawn
Mower
6.1

Attaching the Handlebar

► Stop the engine.
► Place the lawn mower on a level surface.
► Fit sleeves (1) onto retainers (2).
► Insert bolt (3) through cable guide (4).
► Press cable (5) into cable guide (4).
► Hold handlebar (6) against retainers (2) so the
bores align.
► Push bolts (3) through the bores from the
inside to the outside.
26
4.6.1.
15.
10.2.
6.1.
8.1.
7.
11.2.
10.1.

6 Assembling the Lawn Mower

► Fit quick-clamping devices (7) onto bolts (3)
and screw in.
► Close quick-clamping devices (7) in the direc‐
tion of the handlebar.
Handlebar (6) is firmly attached to retainers (2)
and quick-clamping devices (7) lie flat against
handlebar (6).
► Press cable (8) into the holder on handle (9).
► Detach the spark plug socket.
► Press control bar for mowing (10) to handle‐
bar (6) and hold.
► Slowly pull starter handle (11) in the direction
of starter rope guide (12).
► Hook starter handle (11) into starter rope
guide (12).
► Release control bar for mowing (10).
► Re-attach the spark plug socket.
Handlebar (6) must not be dismantled again.
6.2 Assembling, Attaching and
Detaching the Grass Catcher
Box
6.2.1

Assembling the Grass Catcher Box

0478-111-9950-A