Charge Status; Assembling The Lawn Mower; Mounting The Handle - Stihl RMA 460 V Notice D'emploi

English
If three LEDs glow red continuously: the lawn mower motor
is too hot. Allow the motor to cool down.
If three LEDs flash red when you activate the trigger switch:
the lawn mower has an electrical malfunction. Do not
operate the lawn mower. Have it checked by an authorized
STIHL servicing dealer before use or storage.
For troubleshooting information, @ 24.

10.1.3 Charge Status

The LEDs on the battery also show the battery's state of
charge.
To determine the battery's state of charge:
1
► Press the button (1) on the battery.
The LEDs on the battery will glow or flash green for about
5 seconds and indicate the state of charge (see
illustration).
For example:
If four green LEDs glow continuously: full charge.
If one green LED is flashing: less than 20 % charge.
20

11 Assembling the Lawn Mower

11.1 Mounting the Handle

WARNING
Make sure the fuse key and battery are removed before
starting assembly.
WARNING
To reduce the risk of injury from loss of control, ensure that
the handle is properly and securely mounted before starting
work. The lower handle and upper handle can be folded
down after rotating the handle knobs. Check that the star
knobs are firmly tightened. Hold the handle at the highest
point with one hand and rotate the handle knobs. Use
80-100%
60-80%
caution and avoid pinching fingers between the parts.
40-60%
20-40%
WARNING
To reduce the risk of pinching fingers between the parts,
hold the handle at the highest point with one hand when
0-20%
loosening the star knobs.
To mount the handle:
► Switch off the lawn mower, @ 15.2.
► Remove the fuse key and battery, @ 13.2 and @ 14.2.
► Position the lawn mower on a level surface.
7
8
► Align the upper part (1) and lower part (2) of the handle so
that the pin (4) engages into the bore (3) on both sides.
11 Assembling the Lawn Mower
2
5
4
1
1
2
6
3
0458-818-8221-A