Displaying The Charge State; Leds On Battery; Assembling The Lawn Mower; Attaching The Handlebar - Stihl RMA 443 C Notice D'emploi

English
charging times see www.stihl.com/charging-
times.
► Recharge the battery fully as described in the
instruction manual for the STIHL AL 101, 300,
500 chargers.
6.2

Displaying the Charge State

1
► Press button (1).
The LEDs illuminate green for approx. 5 sec‐
onds to indicate the charge state.
► If the right LED flashes green: charge the bat‐
tery.
6.3

LEDs on Battery

The LEDs can show the state of charge or mal‐
functions. The LEDs can glow or flash green or
red.
The state of charge is indicated when the LEDs
glow or flash green.
► If the LEDs glow or flash red: Troubleshooting,
20.1.
There is a malfunction in the mower or battery.
7 Assembling the Lawn
Mower
7.1

Attaching the Handlebar

► Switch the lawn mower off, pull out the activa‐
tion key and remove the battery.
► Place the lawn mower on a level surface.
► Press sleeve (1) into the bores in upper han‐
dlebar (2).
► Fit spring washers (3) with the convex side
facing inwards onto sleeve (1).
30
80-100%
60-80%
40-60%
20-40%
► Guide upper handlebar (2) into handlebar
bracket (4).
0-20%
► Push bolt (5) through the bores in handlebar
bracket (4) and the sleeve in upper handle‐
bar (2).
► Place nut (6) in the notch in handlebar
bracket (4).
► Tighten bolt (5).
► Press cable (7) into holders (8).
► Fasten cable (7) to the handlebar using cable
clip (9).
The handlebar must not be dismantled again.
7.2
7.2.1
► Fit upper part of grass catcher box (1) onto
lower part of grass catcher box (2).

7 Assembling the Lawn Mower

Assembling, Attaching and
Detaching the Grass Catcher
Box

Assembling the Grass Catcher Box

0478-131-9946-B