Connecting Peripheral Equipment; Initial Start-Up; Power Display; Bar Graph Display - KERN EW Série Mode D'emploi

5.5

Connecting peripheral equipment

The balance must be disconnected from the mains before connecting or disconnect-
ing additional equipment (printer, PC) to or from the data interface (see chap. 8.)
Only use KERN accessories and peripheral equipment with your balance. These
have been ideally coordinated to your balance.
5.6

Initial start-up

A warm-up time of 10 minutes stabilises the measured values after switching on.
The accuracy of the balance depends on the local acceleration of the fall.
Please be sure to observe the information in the chapter on adjusting (chap. 5.7).

5.6.1 Power display

If the (*) sign can be seen, the balance is being
supplied with power via the mains adaptor. The
balance is in weighing mode when the
operated.
The power display is then no longer to be seen
on the display overview.

5.6.2 Bar graph display

weighing dish unloaded
The weighing range of the balance is divided into 20 graphic cuboids. Zero (0) will
appear on the graphic display if there is no weighing value on the balance. 10 graph-
ic cuboids are displayed if the balance is loaded up to one half of its weighing range.
Information:
If tare weighing is being carried out, the graphic weight display will continue to indi-
cate the number of cuboids of the tare weight.
EW/EG-N/EWB-e-1627
key is
half of weighing range
*
weighing range is used
to full capacity
19