Entering The Limit Values By Weighing - KERN EW Série Mode D'emploi

6.2.4.2 Entering the limit values by weighing

Important information !
Always begin by entering the lower limit value, followed by the upper limit
value.
Operation
1. Use the key to switch the balance
on.
Set to tolerance weighing:
Press the key until [L. SEt] appears
and then release.
2. The tolerance mark
The lower limit value can be set.
Place a sample for the lower (i.e. small-
er) limit value on the weighing plate:
Store using the key. The stored lower
weight value is displayed briefly.
Entry is now completed if 1 tolerance
mark was selected in the basic setting
(see chap. 7.2.1).
42
ο
-
will flash [ ].
M
M
Display
0 I I I F
0.000
g
L. SEt
0.000
g
93.835
g
EW/EG-N/EWB-e-1627