Battery Operation; Connection Of Peripheral Devices; Initial Commissioning - KERN FKTF 3K0.5LM Mode D'emploi

5.4 Battery operation


To insert the batteries (6 x 1.5 V) remove the battery compartment cover. Remove
it with the help of a coin.

In the each battery tube insert three batteries in the same polarity sense.

Screw down again the battery cover.
To save the battery, the background illumination can be switched off (G10).
If the battery voltage drops below a critical value for operational safety, turns off the scale.

5.5 Connection of peripheral devices

Before connecting or disconnecting of additional devices (printer, PC) to the data interface,
always disconnect the balance from the power supply. With your balance, only use acces-
sories and peripheral devices by KERN, as they are ideally tuned to your balance.

5.6 Initial Commissioning

A warming up time of 2 hours after switching on stabilizes the measuring values.
The accuracy of the balance depends on the local acceleration of gravity.
Strictly observe hints in chapter "Adjustment".
10 FKTF-BA-e-1613