Fault Correction - Grizzly BRM 51-170 A-OHV Q-360 E-Start Traduction De La Notice D'utilisation Originale

All manuals and user guides at all-guides.com
Troubleshooting
Problem
Engine does not
start
The motor will
stop with even the
slight-est give on
the safety bar (
3)
Engine starts but
equipment does
not run at full power
Engine splutters,
stops
Engine overheats
Drive does not
switch on
Output unsatis-
factory or engine
labouring
Blade does not turn
Abnormal noises,
rattling or vibra-
tions
Possible Cause
Too little petrol in the tank
Incorrect starting sequence
Spark plug connector (
put on correctly
Sooted spark plug (
Incorrectly adjusted carburettor
mix
Battery ( 34) empty
Bowden cables (
erly set
Bowden cables (
erly set
Dirty air filter ( 13)
Incorrectly adjusted carburettor
mix
Incorrectly adjusted carburettor
mix
Sooted spark plug (
Ventilation holes blocked
Incorrect spark plug (
Too little engine oil in the engine
Bowden cables ( 30) misad-
justed
Grass too short or too long
Blade blunt
Blade blocked with grass, grass
collection box full (
tion channel blocked
Blade blocked with grass
Blade not installed correctly
Blade not installed correctly
Blade damaged

Fault Correction

Fill with petrol
Follow the instructions for starting the
engine (see "operation")
Attach the spark plug connector
11) not
Clean, adjust or replace the spark plug
(see "cleaning and maintenance")
30)
Have the carburettor adjusted by a spe-
cialist workshop
Charge battery
Set Bowden cable (see "Setting the
) not prop-
Bowden cable") or have a specialist
workshop set it
Set Bowden cable (see "Setting the
) not prop-
Bowden cable") or have a specialist
workshop set it
Replace the air filter (see "cleaning and
maintenance")
Have the carburettor adjusted by a spe-
cialist workshop
Have the carburettor adjusted by a spe-
cialist workshop
Clean, adjust or replace the spark plugs
30)
(see "cleaning and maintenance")
Clean the ventilation slot
Change the spark plug
30)
Fill with engine oil (see "initial opera-
tion")
Adjust the Bowden cables or have
P
them adjusted by a specialist workshop
Change the cutting height (see "setting
the cutting height")
Have the blade sharpened or replaced
by a specialist workshop
Remove the grass (see "cleaning and
19), ejec-
maintenance")
Remove the grass
Have the blade installed by a specialist
workshop
Have the blade installed by a special-
ist workshop
GB
117