Fuel Filter - Stiga PARK UNLIMITED Mode D'emploi

All manuals and user guides at all-guides.com
Do not fill with too much oil. This can cause the
engine to overheat.
Change oil when the engine is warm.
The engine oil may be very hot if it is
drained off directly after the engine is
shut off. Therefore allow the engine to
cool a few minutes before draining the
oil.
1. Attach the clamp on the oil drainage hose. Use
a polygrip or similar. See fig. 15-17:Y.
2. Move the clamp up 3-4 cm on the oil drainage
hose and pull out the plug.
3. Collect the oil in a collection vessel.
NOTE! Do not spill any oil on the drive belts.
4. Hand in the oil for disposal in accordance with
local provisions.
5. Install the oil drainage plug and move the clamp
back so that it clamps above the plug.
6. Remove the dipstick and fill with new oil.
Oil quantity:
Machine Oil volume, approx.
No filter Filter replace-
replacement
Unlimited -
President -
Power 1,9 liter
Excellent 1,6 liter
7. After filling up the oil, start the engine and idle
for 30 seconds.
8. Check to see if there is any oil leakage.
9. Stop the engine. Wait for 30 seconds and then
check the oil level in accordance with 4.2.
5.4.3 Oil filter(Power)
The oil filter must be replaced during every second
oil change, i.e. after 200 hours of operation. First
drain the engine oil and install the oil drainage plug
as described above. Then replace the oil filter as
follows:
1. Clean the area around the filter and dismantle
the filter.
2. Place the new filter with the hole facing up-
wards in a vessel.
3. Fill up with the new engine oil through the hole
in the filter until the level reaches the bottom of
the thread.
4. Wait 1-2 minutes so that the oil is absorbed by
the filter material.
5. Moisten the filter's gasket with oil.
6. Install the filter. First screw in the filter so that
the gasket comes into contact with the engine.
Then screw in the filter a further 2/3-1 turn.
7. Continue with point 7 in accordance with 5.4.2
Engine Oil above.
ENGLISH
5.4.4 Oil filter (Excellent)
The oil filter must be replaced during every second
oil change, i.e. after 100 hours of operation. First
drain the engine oil and install the oil drainage plug
as described above. Then replace the oil filter as
follows:
1. Clean the area around the filter and dismantle
the filter.
2. Moisten the new filter's gasket with oil.
3. Install the filter. First screw in the filter so that
the gasket comes into contact with the engine.
Then screw in the filter a further 1/2-3/4 turn.
4. Continue with point 7 in accordance with 5.4.2
Engine Oil above.

5.5 Fuel filter

Unlimited, President, Power
Replace the fuel filter every season.
Excellent
Replace the fuel filter after 1,500 hours of opera-
tion.
Check for fuel leaks once the new filter has been
installed.
ment
5.6 Belt transmissions
1,6 liter
After 5 hours of operation, check that all the belts
1,6 liter
are intact and undamaged.
2,0 liter
5.7 Steering
1,7 liter
The steering must be checked/adjusted after 5
hours of operation and thereafter after 100 hours of
operation.
5.7.1 Checks
Briefly turn the steering wheel back and forth.
There must be no mechanical clearance in the
steering chains.
5.7.2 Adjustment
Adjust the steering chains if required as follows:
1. Put the machine in the straight-ahead position.
2. Adjust the steering chains with the two nuts, lo-
cated under the central point. See fig. 26.
3. Adjust both nuts by the same amount until there
is no clearance.
4. Test drive the machine straight forwards and
check that the steering wheel is not off centre.
5. If the steering wheel is off centre, undo one nut
and tighten the other.
Do not over-tighten the steering chains. This will
cause the steering to become heavy and will in-
crease wear on the steering chains.
EN
59