Jotul FS 84 Advance Manuel D'installation Et D'utilisation page 10

ENGLISH
Fig. 6
B
7. When using outside air connection through the fl oor (optional
extra, item no. 51012164), this must be fi tted now. Make a
hole in the recess (A) for the external air hose at the rear of
the bottom section. Route the hose out through the hole in
the bottom section.
8. Put the bottom plate (fi g. 1 - part 11) in place. Check using
a spirit level (B) and adjust as necessary using adhesive or
mortar. NB: It is extremely important that the bottom
plate is steady and level.
Fig. 7
9. Insert the base (fi g. 1 - part 1) in the slots in the bottom
plate. Check that it is level.
Fig. 8
A
B
10. Put the back plate (A) in place. The rear section has two
protrusions that slot (B) into the base.
10
Fig. 9
A
11. Position the burn chamber in the four grooves in the base
Fig. 10
B
12. Adjust the burn chamber to fi t the hollow (A) on the inside
(fi g. 1 - part 1). Level and adjust the burn chamber vertically
using the long nuts in the adjusting kit. Make sure the burn
chamber is fl ush with the front of the base. If using an
external air supply, make sure that the fl exible hose for the
outside air connection is not trapped. Route the hose out
through the hole in the rear of the base.
of the rear plate.
A