High Model - Jotul FS 84 Advance Manuel D'installation Et D'utilisation

4. 2 Assembly of the Jøtul FS 84 -

high model

Fig. 2
1. Spread the cardboard packaging over the fl oor, and lay the
stove down carefully on its side.
Fig. 3
6 mm
2. Screw in the 4 screws (fi g. 1 - part 3) approx. 10 mm and
lock in place with counter nuts. Then screw in the sleeve
nuts M8 x 30 (fi g. 1 - part 7) until about 6 mm away from
the counter nuts (fi g. 1 - part 6).
Replacing the control handle on the burn chamber
The control handles on the Jøtul FS 84 Advance must be
replaced with the handles provided in the box.
Fig. 4
A
B
C
A
A
E
3. Unscrew the stud bolts and nuts (A) and remove the
handles (B and C).
4. Unscrew the spacer (D) and lever (E).
5. Fit the new lever set in the same place.
D
Fig. 4 B
6. Make sure that the arrow on the inside of the lever is
pointing towards the centre of the handle set.
4.3 Outside air connection (optional
extra)
Fig. 5
• If the outside air connection (A) (item no. 51012164) is to
be used, this must be fi tted now. Refer to the manual for
the Jøtul F 370 Advance (item no. 10050848) and manual
(item no. 10026187) for Ø 100 mm outside air connection.
ENGLISH
A
17