Safety Instructions - Kospel EPJP Serie Mode D'emploi

Safety instructions

1. Read and strictly follow this installation and operating instructions to ensure a
long life and reliable heater operation.
2. Connection to the mains and measurement of fire protection effectiveness should
be made by a qualified person.
3. The unit has to be earthed or neutrally grounded.
4. The unit must be permanently connected to the mains.
5. The unit must not be installed in the room which is exposed to the danger of
explosion or room in which the temperature may go down below 0°C.
6. The unit can only be used when in perfect technical condition and correctly
assembled.
7. The unit should always be vented before initial start-up. Vent the unit each time
after the water has been emptied from the heater or pipes (e.g. when water
supply system has been repaired or maintained).
8. This unit can only work with the mixer included in the product box.
9. The unit must not be installed where it will be exposed to direct spray from
shower head.
10. The outlet system of the heater (mixer – shower head) works as an air vent and
therefore, cannot be connected to any valve or a connector that is not recom-
mended by the manufacturer.
11. Do not use when the water has been emptied from the unit or pipes (e.g. when
water supply system has been repaired or maintained).
12. Cut off power supply to the unit before you take off the heater enclosure.
13. Do not install any other appliance/s to the outlet pipe of mixer, do not clog or
block up the outlet pipe or shower head when the water is running.
14. Appropriate precaution must be taken when using hot water. Temperature of
water over 40°C may cause hot feeling and can be dangerous for children.
15. It is necessary to regularly clean the shower head from the limescale.
PL;DE;FR;GB;LV;RU;EE-003AB_f.678
GB
15