Managing Battery Memories - GM COMMANDER SPORT Instructions D'utilisation

22. Managing battery memories

SAVE DATA:
The GM Commander SPORT has a total of five memories in which the battery parameters for Charge, Discharge and Cycle
can be stored. This facility enables you to store profiles for the batteries you most often use, eliminating the need to program
the charger when you switch to a different battery.
Press the 'Batt. Type / Stop' button to move to the PROGRAM SELECT - SAVE DATA menu. Press 'Start - Enter', and the
memory number (in this case 01) starts to flash. You can now select the battery memory you wish to use with the DEC or INC
Capacity
Battery
Battery type
voltage
Program button. Pressing the 'Start - Enter' button again selects this memory, and takes you on to the battery type (in this case NiMH),
3 sec.
number
which can be changed in the same manner. Repeat the procedure with the battery voltage and capacity.
Hold the 'Start - Enter' button pressed in for about three seconds to move to the CHARGE menu, where a flashing asterisk at
the top right-hand corner indicates that the parameters can be programmed. Briefly pressing the 'Start - Enter' button causes
the charge current to flash; you can now set this value as described earlier in the individual charge programs.
Note: in certain charge programs you can also press the INC button to move on to supplementary program points, e.g. BA-
LANCER in LiPo mode.
Hold the 'Start - Enter' button pressed in again for about three seconds to move to the DISCHARGE menu. The settings are
entered as described under CHARGE.
Now hold the 'Start - Enter' button pressed in once more for about three seconds to move on to the remaining menus.
3 sec.
Note: the program segments available vary according to the charge program you have selected.
Once you have set all the programming parameters, hold the 'Start - Enter' button pressed in for three seconds; the screen
displays SAVE, and your settings for this battery memory are stored.
LOAD DATA:
LOAD DATA is used to select one of the battery memories you have already programmed using SAVE DATA.
Press the 'Batt. Type / Stop' button to move to the PROGRAM SELECT - LOAD DATA menu. Press 'Start - Enter', and the
memory number (in this case 01) starts to flash. You can now select the battery memory you wish to use with the DEC or INC
button. Pressing the 'Start - Enter' button again selects this memory.
Hold the 'Start - Enter' button pressed in for about three seconds, and LOAD appears on the screen; your settings are loaded.
3 sec.
56
All manuals and user guides at all-guides.com
Operating Manual GM COMMANDER SPORT