Lixx Discharge Program - GM COMMANDER SPORT Instructions D'utilisation

16. LiXX discharge program

Discharging LiXX:
The GM Commander SPORT can also be used to discharge batteries, typically in order to ascertain the remaining capacity
after a run.
ATTENTION: if the balancer lead is not connected, the individual cells will not be balanced!
3 sec.
LiPo DISCHARGE:
Press the 'Batt. Type / Stop' button to move to the PROGRAM SELECT - LiPo BATT menu. Now press 'Start - Enter' for the 'LiPo
DISCHARGE' menu.
The default pre-set charge current and cell count are displayed on the screen. If you wish to change these settings, press 'Start
- Enter' again: the charge current starts to flash, and can now be changed using the DEC or INC button. Pressing the 'Start -
Enter' button again takes you to the cell count, which can be adjusted in the same manner.
Battery
voltage
Number
When the settings are correct, hold the 'Start - Enter' button pressed in for three seconds; the charger then initiates the auto-
of cell Charging
charged
time
capacity
matic cell detect process BATTERY CHECK (please refer to Chapter 11 for details of programming the CHK time), and displays
Charging current
the values on the screen. If everything is correct, press the 'Start - Enter' button to initiate the charge process; if you need to
correct the values again, you can interrupt the process with 'Stop'.
To interrupt the charge process before it terminates automatically, press the 'Stop' button.
WARNING: it is absolutely essential to enter the correct discharge current and cell count at this point, otherwise
the battery may be damaged or - worse - ignite or even explode!
If you press the INC button during the charge / discharge process, the screen will display the individual cell voltages of the
battery connected to the charger. Pressing the INC button again takes you back to the Charge display.
Note: if the voltage of one cell differs substantially from the others during the charge / discharge process, the screen displays the
warning BATTERY VOL ERROR, and the charger halts the process; the screen also shows the CELL LOW VOL alert (= low cell
voltage). Pressing the INC button again at this point takes you to a display of the individual cell voltages, where you can see that
the voltage of cell 3 is too low, and the balancer is unable to correct it. If this should happen, your battery needs to be checked.
50
All manuals and user guides at all-guides.com
Operating Manual GM COMMANDER SPORT