Camera Power Supply; Camera Power Supply Installation - Videotec HOV Manuel D'instructions

7.2 Camera power supply

7.2.1 Camera power supply installation

Not usable in housings with wiper device
installed.
Pay attention to the voltage used to power
the circuit. Depending on requirements
use the correct power supply kit.
Usable power supplies:
• IN from 100Vac up to 240Vac, 50/60Hz - OUT
12Vdc, 1.25A
• IN 230Vac, 50Hz - OUT 24Vac, 50Hz, 400mA
Fig. 10 Camera power supply.
10
Open the housing as described in the relative
chapter (6.1 Housing opening, page 6).
Fix the support bracket (02) using the screw (01).
Place the power supply (03) on the support bracket.
Secure it all with the screws (04) and the corner
fixing bracket (5).
05
03
02
Fig. 11
Plug the multipolar female connector into the
corresponding male connector (J7, 6.3 Board
description, page 7).
Fig. 12
04
01
MNVCHOV32_2222_EN