Stop Irregular Cycle; T.probe Unconnect; Time-Out Alarm Filling Up; No Water - Expobar Brilliance Mode D'emploi

If you are refilling coffee beans after having get the "No Coffee" signal, the machine will be
showing the error "No Coffee". To reset this error after having refilled the machine, restart the
machine, turning off the main switch, and again, turning it on.
18.2.2

Stop irregular cycle

If due to any reason, the group does not reach certain positions in a determined time, we will get a
"Stop irregular cycle". In this case, the machine has to be revised by your technical service.
18.2.3

T.Probe Unconnect

The electronics of the machine has detected a failure in the connection of the water Temperature
probe. Disconnect the machine and make the machine be revised by the technical service.
18.2.4

Time-out alarm Filling Up

An excessive time has been detected to fill up the Airbreak deposit. Check that the water connection
to the machine is correctly open. A pressure at the inlet too low will cause the same problem.
Note: Some times more than one automatic machine are connected to the same water supply; and
from time to time, both machines will try to get water simultaneously from the supply, failing the
supply to give enough water for both demands, causing this alarm to appear. This can be solved
connecting each machine to an independent water supply.
18.2.5

No water

If after beginning pumping water during erogation of an espresso, no water is detected flowing
through the flow measurer, a "No water error" will appear on the screen.
This can be caused by:
- Commonly this will be caused by the adjustment of the grinder being too thin, preventing
the water from getting through. Try to adjust a coarser grade on the grinder; then try making
two more espressos, as to clean the already remaining grinded coffee in the interior of the
grinder; watch the results with the third coffee.
- Or much more rarely, maybe there is a problem with the flow measurer. Then the machine
has to be checked by the Technician.
18.2.6

Coffee doser error

If after activating the opening of the grinded coffee doser, the machine detects a failure on its
detector, an "Error dosific." will be displayed. Disconnect the machine and make the machine be
revised by the technical service.
18.2.7

Security anti flooding

If, for any reason, there is some kind of leakage of water inside the machine, and the machine
detects a consumption of water without any requested beverage; the third time that the machine has
to refill the Air break being the machine idle, we will get the "Alarma Time-Out inundacion" alarm.
Disconnect the machine and make the machine be revised by the technical service.
18.2.8

Alarm temperature Boiler

Case that the temperature probe of the boiler, sensed a temperature over a certain security value for
more than 5 secs, o in case that the temperature probe got short-circuited for any reason, on the
display we would get an "alarm temperature Boiler" and the heater would get disconnected. The
error will remain as long as the defect is present.
We recommend that in this case, the machine get disconnected and got sent to the technical service.
All manuals and user guides at all-guides.com
55
• Alarms & Display Messages
English