Machine Installation; Suitable Locations; Water Connection; Electrical Connection - Expobar Brilliance Mode D'emploi

All manuals and user guides at all-guides.com

• Machine installation

12 M
ACHINE INSTALLATION

12.1 Suitable locations

This distributor is not suitable for outdoors service.
The machine must be installed in dry locals, and should not be cleaned projecting water against it.
Machine should not be exposed to temperatures under 1ºC.
When installing the machine near a wall, make yourself sure that the door can be wide open and
ensure yourself as well, that the fan's grill at the right side of the machine, is not covered.
Don't ever cover the machine with plastic film or cloths.

12.2 Water connection

After unpacking the machine and placing the machine in its final location:
Level the machine by turning its rotating feets.
Connect the machine to a water inlet of drinkable water. We recommend to have a valve to cut the
water to the machine if necessary. Pressure arriving to the machine should be between 1,5 and 8
bars.
Make sure that the water hose not are kinked anywhere when machine is
pushed into place.
Note: It is advised, to split some water out of the water outlet being used, as to let possible dirt out
of it.

12.3 Electrical connection

Connect the machine to a grounded 230VAC 50Hz connection or a grounded
110VAC 60Hz connection (depending on the model); check the adequate
voltage and frequency at the back of the machine.

12.4 Initialization

When the machine is new received, its boiler is not completely full of water. And the Airbreak (a
small deposit open to air inside the machine) will be empty. So prior to normal service, the
machine's system has to be filled up. As to do that; follow the next procedure:
1.- First, install the machine correctly in its final location.
2.- Connect the machine; and without waiting it to warm up, just press any selection that has
espresso on its recipe, or the selection for water for infusion; It is important to use one of these as
to really fill up the boiler; filling would not work as well with only soluble drinks.
3.- Repeat selecting an espresso / water for tea selection, till water comes out from the coffee or the
"water for tea", nozzle. When this happens, boiler is ready.

12.5 Water softener

It is strongly recommended to use a water softener / filter to supply water to the machine. This will
remove estrange flavors from the water, and will avoid any limescale to build up and provoke
problems.
English 32