Working With The Machine; Service And Maintenance; Environment; Eu Declaration Of Conformity - Festool CMS-TS 75 Notice D'utilisation D'origine

GB CMS-TS 75
 Prior to use, check whether the actual and indi-
cated cutting depths are the same (e.g. at 0
mm). If necessary, you can loosen the screw
[11-3] and realign the cutting depth indicator.
8.2 Adjusting the stop
The accompanying stop can be attached to all four
sides of the machine (Fig. [12]).
Clamping the workpiece!
Secure the stop to the front of the base in
front of the saw blade!
The stop can be adjusted in the following ways:
• Adjustment parallel to the bench edge - unscrew
the rotary knob [12-8].
• Adjustment at right angles to the bench edge -
unscrew the rotary knob [12-6].
• Adjustment of the stop ruler [12-1] lengthways -
unscrew the rotary knob [12-4]. The stop ruler
can be moved to a lower position for thinner
workpieces (Fig. [12A]) or a higher position for
thicker workpieces (Fig. [12]).
• Angle adjustment using the scale [12-5] - un-
screw the rotary knob [12-3] and lift the retaining
pin [12-2]. The rotary retaining pin engages in
the most common angle positions.
 Turning the retaining pin blocks the stop.
Make sure that all rotary knobs on the stop
are tightened before starting work. The stop
should always be used in a fixed position and
not to slide the workpiece.
9

Working with the machine

Observe the following instructions:
Adjust the top protective cover until it rests on

the workpiece and secure in this position using
the rotary knob [9-1].
Use the fence as a longitudinal stop to guide the

workpiece.
You can adjust the cutting width using the scales

[10-1].
Guide the workpiece by hand. Use the push stick

[12-7] to guide the workpiece safely past the
saw blade.When not in use, place the push stick
in the store [12-9].
14
All manuals and user guides at all-guides.com
10
Risk of injury, electric shock


Damaged safety devices and components must be
repaired or replaced in a recognised specialist
workshop, unless otherwise indicated in the oper-
ating manual.
EKAT
Maintain the machine regularly to make sure it
functions correctly:



11
Do not dispose of electric power tools in house-
hold waste! Recycle devices, accessories and
packaging. Observe applicable country-specific
regulations.
EU only: In accordance with European Directive on
waste electrical and electronic equipment and im-
plementation in national law, used electric power
tools must be collected separately and handed in
for environmentally friendly recycling.
Information on REACh: www.festool.com/reach
12
Retaining panel for portable
circular saws
CMS-TS 75

Service and maintenance

WARNING
Always disconnect the mains plug from the
socket before performing maintenance work on
the machine!
All maintenance and repair work which requires
the motor housing to be opened must only be
carried out by an authorised service workshop.
Customer service and repair only
through manufacturer or service
workshops: Please find the nearest
address at: www.festool.com/service
Only use original Festool spare parts!
4
Order No. at: www.festool.com/service
5
3
2
1
Use an extractor to remove dust deposits.
Replace worn or damaged table inserts.
On completion of your work, wind the power ca-
ble around the holders [12-9].

Environment

EU Declaration of Conformity

Serial no.
493360