Stihl RB 302 Mode D'emploi page 6

English
Detergent
Unsuitable detergents can cause
damage to health, as well as to the
machine and the object to be cleaned.
Contact a dealer if in doubt.
STIHL recommends the use of genuine
STIHL detergents. Follow the
instructions for use.
Chemical detergents may contain
physiologically harmful (toxic, caustic,
irritant), flammable or explosive
substances. Note the manufacturer's
safety data sheets!
Detergents should always be used in the
proportions specified by the
manufacturer.
Before starting work
Do not connect the high-
pressure cleaner directly
to the drinking water
main.
Only connect the high-pressure cleaner
to the drinking water main in conjunction
with a backflow preventer – see "Special
accessories".
Do not use the machine with dirty water.
If there is a risk that dirty water will occur
(e. g., flowing sand), an appropriate
water filter must be used.
Check that the high-pressure cleaner is
in full working order. Pay particular
attention to the high-pressure hose, the
spray attachment, the safety parts and
the fuel system. Note the relevant
chapter of the instruction manual:
4
All manuals and user guides at all-guides.com
Inspecting the high-pressure cleaner
The high-pressure cleaner should only
be used if it is in full working order – risk
of accident!
– It must be possible to move the
switch to the 0 position easily
– Check that the spark plug boot is
secure. A loose boot can lead to
flying sparks which may ignite the
escaping fuel/air mixture – risk of
fire!
– Inspect the high-pressure hose,
spray attachment and safety
mechanisms for damage
– High-pressure hose and spray
attachment in good condition
(clean, moving easily) and correctly
assembled
– For good control of the machine, the
handles should be clean and dry
with no oil or dirt on them
– Check the oil level
– Never attempt to modify the controls
or safety devices
Starting the engine
Start the engine as described in the
engine manual.
Move at least 3 meters away from the
place at which the machine was refueled
and never start the machine in enclosed
spaces.
Place the machine on a flat surface and
ensure a firm and safe footing.
The machine is operated by only one
person. There should not be any other
person within the working area, not even
when starting the machine.
Check that the speed drops: the engine
must idle when the operator releases the
trigger on the spray gun.
During work
Ensure you always have a firm and safe
footing.
Beware of slipping on ice, water, snow
or uneven ground!
Keep the high-pressure cleaner as far
away as possible from the object being
cleaned. Keep the machine at least 1 m
away from buildings while working.
Switch off the engine immediately in the
event of imminent danger or in an
emergency.
Never direct the high-
pressure jet or water
hose against electrical
appliances and equip-
ment – danger of short-
circuiting!
Never direct the high-
pressure jet or water
hose against electrical
equipment, connections
and power cables – dan-
ger of short-circuiting!
Never direct the high-
pressure jet against your-
self or other people, not
even to clean clothing or
shoes – risk of injury!
RB 302, RB 402 PLUS