Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
:
Retract wheels, if fitted
:
Put the unit on the ground:
It must rest securely on the engine
flange and on the support on the
frame.
:
Check that the MultiTool is not
touching the ground or any other
obstacles – refer also to "Starting /
Stopping the Engine" in the
instruction manual of the MultiTool
you are using.
:
Make sure you have good balance
and secure footing – as shown in
the illustration. To reduce the risk of
injury from contact with rotating
attachments, always stand to the
side of the power tool.
MM 55
All manuals and user guides at all-guides.com
:
With your left hand on the loop
handle, press the unit firmly against
the ground.
Do not stand or kneel on the
handlebar!
:
Pull the starter grip slowly with your
right hand until you feel it engage –
then give it a brisk strong pull.
Do not pull out the starter rope
completely –
it might break.
:
Do not let the starter grip snap
back – guide it slowly into the
housing so that the starter rope can
rewind properly
8
:
Continue cranking until the engine
begins to fire. After no more than
five pulls, move the choke lever (8)
to the e position
:
Continue cranking.
As soon as the engine runs:
:
Blip the throttle trigger –
the engine returns to idling speed
Make sure carburetor is correctly
adjusted – tool must not move when
engine is idling!
Your unit is now ready for operation.
To shut down the engine:
:
Move the slide control in the
direction of the arrow ( h ) to
STOP – $
English
15
Publicité
Chapitres
Table des Matières
