Installing The Child Seat: Harness Mode; Checklist - Britax FRONTIER CT Guide D'utilisation

Installing the Child Seat: Harness Mode

Lap-Shoulder Belt with CLICKTIGHT
Before you begin:
• Check that your vehicle has a top tether anchor.
The top tether must be used at all times when installing
*
the child seat in harness mode. Using the top tether will
improve the stability of your child seat and reduce the
risk of injury. Check your vehicle owner's manual for
tether anchor locations.
• Loosen the Versa-Tether and place it over the child seat
back to keep it from becoming pinned between the child
seat and vehicle seat during installation.
• Adjust the child seat to desired position and place forward
facing on the vehicle seat.
Release the buckle and open
1
the CLICKTIGHT.
* Locate the two slots in the
CLICKTIGHT cover.
* Squeeze the CLICKTIGHT
release levers.
8
All manuals and user guides at all-guides.com
Installing the Child Seat: Harness Mode
Pull the vehicle belt out and
2
route along the green belt
path. Verify that the belt is not
twisted and then buckle.
Remove slack from the lap
3
part (a), then shoulder part (b)
of the vehicle belt.
Close the CLICKTIGHT.
4
* A click confirms the
CLICKTIGHT is secure.
* The child seat is secure when
it cannot be moved front-to-
back or side-to-side more than
2.5 cm (1 in.) at the belt path.
If the child seat is not secure,
repeat the installation procedure
or use a different seating
location.
Firmly press the Versa-Tether
5
hook over a designated
vehicle tether anchor. Remove
slack.
Secure excess webbing with
6
the elastic strap.

Checklist

Check all connections and verify that child seat is secure.
* The child seat is secure when it cannot be moved front-to-
back or side-to-side more than 2.5 cm (1 in.) at the belt path.
If the child seat is not secure, repeat the installation procedure
or use a different seating location.
Check that any excess Versa-Tether webbing is contained
within your vehicle and secured in the elastic strap.
3b
3a
OR
OR
9