Transportation And Storage - Steinberg SBS-TW-3000/100 Mode D'emploi

FUNCTIONS OF THE KEYS
„ON / OFF": Press the ON / OFF button to start the unit. The scale will switch off if upon switching it on,
the display shows the message "UnST". This message means that the scale is placed on an unstable base -
place the scale on a stable base which is not exposed to vibrations and shock.
„M" button: The unit change is possible by pressing the "M" button. Then press up to reach the desired unit.
Units can be selected from the following: g / gn / oz / ozt / dwt / ct / tl.
Counting function „PCS": Put the desired number of pieces on the scale dish (it must be 25, 50, 75 or
100). Press and hold the PCS button for about 2 seconds, the display will show "100". Then press the "M"
button to select the number corresponding to the number of pieces on the scale dish - 25, 50, 75 or 100.
Press PCS to confirm the selection. The scale will show the number of pieces put on the scale dish. To exit
the piece calculation mode, press the "M" button.
Tare key „T": Press this button to subtract the weight of a container or any weight on the scale. This key
is also used for zeroing the scale.
FUNCTION OF TARE
1. Place an empty container on the weighing platform until the balance indicates a stable value. Then press
„M". Your balance now displays „0". To exit the tare function, remove the container and repress the
„ZERO" button. Your scale is back to normal.
2. The range of tare: entire load range.
AUTO-ZERO
Press „M" if the scale does not show „0" when nothing is placed on it.
EN
The scale must not be overloaded.
CALIBRATION
Switch the scale on. Press and hold the "M" button until the display shows "CAL". Release the "M" button
then press it again - "CAL" on the display will start to flash and moments later the display will show the
flashing standard load value. Put the indicated standard load value on the scale dish and wait for the scale
to stabilise. Then, depending on the model, calibration will be completed or the display will show another
flashing standard load value which must be placed on the scale dish for the scale to stabilise. When the
calibration is completed, a flashing "PASS" message is displayed on the display. Upon completion of calibration
turn the scale off and on again.

TRANSPORTATION AND STORAGE

Shaking, crashing and turning upside down of the device should be prevented when transported. Store it in a
properly ventilated surrounding with dry air and without any corrosive gas.
REGULAR CONTROL OF THE DEVICE
Regularly control that the device doesn´t present any damage. If there is any damage, please stop using the
device. Please contact your customer service to solve the problem.
What to do in case of a problem?
Please contact your customer service and prepare following information:
• Invoice number and serial number (the latter is to be found on the technical plate on the device).
• If relevant, a picture of the damaged, broken or defective part.
• The more detailed your information, the better the customer service will be able to solve your problem
rapidly and efficiently!
CAUTION: Never open the device without the authorization of your customer service. This can lead to a loss of
warranty!
10
MODE D'EMPLOI
BALANCE DE TABLE
FR