Transportation And Storage - Steinberg SBS-TW-3000/100G Mode D'emploi

FUNCTIONS OF THE KEYS
„ON / OFF":
Press the ON / OFF button to start the scale.
„M" button:
The unit change is possible by pressing the "M" button. Then press up to reach the desired unit. The following
units can be selected: g / oz / lb / kg / tl / ct.
Counting function „PCS": Put the desired number of pieces on the scale dish (it must be 25, 50, 75 or
100). Press and hold the PCS button for about 2 seconds, the display will show "100". Then press the "M"
button to select the number corresponding to the number of pieces on the scale dish - 25, 50, 75 or 100.
Press PCS to confirm the selection. The scale will show the number of pieces put on the scale dish. To exit
the piece calculation mode, press the "M" button.
Tare key „T": Press this button to subtract the weight of a container or any weight on the scale. This key
is also used for zeroing the scale.
FUNCTION OF TARE
1. Place an empty container on the weighing platform until the balance indicates a stable value. Then press
„M". Your balance now displays „0". To exit the tare function, remove the container and repress the
„ZERO" button. Your scale is back to normal.
2. The range of tare: entire load range.
AUTO-ZERO
Press „M" if the scale does not show „0" when nothing is placed on it.
EN
The scale must not be overloaded.
CALIBRATION
Switch the scale on. Press and hold the "M" button until the display shows 500 (in case of the SBS-TW-
500/10G) / 3000 (in case of the SBS-TW-3000/100G). Release the "M" button, then press it again - the display
will show "CAL" and a flashing standard load value in grams: 200 (in case of the SBS-TW-500/10G) / 2000
(in case of the SBS-TW-3000/100G). Put the indicated standard load value on the scale dish and wait for the
scale to stabilise. Then the display will show another flashing standard load value in grams (500 in case of the
SBS-TW-500/10G / 3000 in case of the SBS-TW-3000/100G) which must be placed on the scale dish for the
scale to stabilise. When the calibration is completed, a flashing "PASS" message is displayed on the display
and the scale turns off.

TRANSPORTATION AND STORAGE

Shaking, crashing and turning upside down of the device should be prevented when transported. Store it in a
properly ventilated surrounding with dry air and without any corrosive gas.
REGULAR CONTROL OF THE DEVICE
Regularly control that the device doesn´t present any damage. If there is any damage, please stop using the
device. Please contact your customer service to solve the problem.
What to do in case of a problem?
Please contact your customer service and prepare following information:
• Invoice number and serial number (the latter is to be found on the technical plate on the device).
• If relevant, a picture of the damaged, broken or defective part.
• The more detailed your information, the better the customer service will be able to solve your problem
rapidly and efficiently!
CAUTION: Never open the device without the authorization of your customer service. This can lead to a loss of
warranty!
Rev. 12.04.2022
10
MODE D'EMPLOI
BALANCE DE TABLE
FR
Rev. 12.04.2022