Publicité
Les langues disponibles
Les langues disponibles
DISPLAY DATA
DESCRIPTION
Strt
Operation modes
no
- Start inputs from terminal board are disabled
StAn
- Standard operation
APCH
- Separated opening and closing commands
PrES
- Manned operation
oroL
- Timer operation
StoP
STOP input
no
- STOP input not available
invE
- STOP command stops the gate: START command starts
moving in the opposite direction
ProS
- STOP command stops the gate: pressing the START command
gate continues the motion
Foto
Photocell input
CFCh
- Photocell is active in closing and also when the gate is still
no
- Not available
Ch
- Photocell is active during the closing
tESt
Test of safety devices
no
- Function not active
Foto
- Test enabled only for photocells
CoSt
- Test only enabled for the safety edges (or for the additional photocells)
Ft.Co
- Test enabled either for photocells or for safety edges
ShAd
Photocell shadow zone
no
- Function disabled
F.ShA
- Time of end disabling
i.ShA
- Time of beginning enabling
CoSt
Border input
no
- Input disabled (the control unit ignores it)
Fot.i
- Input enabled for the additional photocells active during opening and closing
rESi
- Input enabled for conductive rubber ribbons
StAn
- Input enabled for standard safety ribbons with normally closed contact
AP.Ch
- Input enabled in opening and closing phase
AP
- Input enabled only in opening phase
Ch
- Input enabled only in closing phase
FC.En
End of stroke inputs
no
- Input disabled (the control unit ignores it)
rALL
- Inputs enabled: the gate starts the slowdown phase (menu t.rAL) near
the limit switches
StoP
- Input enabled: the gate stops near the limit switches
i.Adi
no/Si
Enabling the ADI device
t.inA
0 ÷ 8
Max. gate quiescent time
ASM
0.5"÷2.0'
Anti-skid
no
- Function disabled
SEnS
0 ÷ 10
Obstacle sensor level
Cont
Counter viewing
tot.
- Total number of completed cycles (views in thousands or in units)
Man
- Number of cycles before the next request for service (such a number has
been rounded off to hundreds and it can be set up on 1000-step; in
case it is set up on 0, the request will be disabled and no will be viewed)
APPr
Automatic learning of the operation time
no
- Function disabled
Go
- Start up of the automatic learning procedure
FinE
End of programming
no
- It does not exit from the program menu
Si
- It exits from the program menu by storing the setup parameters
43
DEFAULT
DEFAULT
MEMO
AntE
SCor
DATA
StAn
StAn
no
no
CHCh
CHCh
no
no
no
no
no
no
no
StoP
no
no
0
0
1.0"
1.0"
5
5
tot
tot
no
no
no
no
Publicité
Chapitres
