Table des Matières
Publicité
CAUTION! - Advice when working on or
using the device. Failure to observe this ad-
vice may result in material damage!
Parameters
Parameters are displayed in grey in the text in
the following structure,
name.
Figures
Figures are indicated using figure numbers in
[square brackets]. A capital letter after a
figure number, for example [12A], refers to a
specific section of the figure.
Intended use
AP 5.4 printers are designed for printing label
material, using the thermal or thermal transfer
printing process. In addition, the AP 5.4
dispenser version can dispense self-adhe-
sive labels and can rewind the remaining
backing paper (ar alternatively the complete
label material). It is possible to use a wide
range of label materials and thermal transfer
ribbons. Label stock must be in roll shape or
fan-folded. The label web can optionally be
pulled-in from outside the printer through the
slots in the rear side or bottom plate.
Any other use or use going beyond this shall
be regarded as abnormal use.
See chapter „Technical Specifications" on
page 128.
User manual AP 5.4, topic section „Specifica-
tions".
CD
NOVEXX Solutions assumes no liability for
damage due to abnormal use of the printer.
Safety notes
Follow the instructions
Safe and efficient operation of the printer can
only be guaranteed if you observe all neces-
sary information.
– Before operating the printer, read the ope-
rating instructions and all other notes care-
fully.
– Observe the additional safety and warning
notes on the printer.
Qualifications required
– Trained staff is required for inserting and
changing foils and material.
All manuals and user guides at all-guides.com
MENU NAME > Parameter
– Users need to be instructed in the use of
the printer so they can work safely and
independently.
– Users should be able to resolve minor ope-
rational issues and faults by themselves.
– At least two users should be instructed.
Requirements for safe operation
– Only use the printer in enclosed areas with
environmental conditions matching the
values given in the technical specifications!
– Only operate the printer on a plane, solid
support.
– Make sure that the power supply socket for
the printer is readily accessible!
– Only trained and authorized personnel
should operate the printer!
– During operation, the printhead can
become hot! Care should be taken when
touching the printhead!
– Do not make any modifications or any addi-
tional casing for the printer!
– Do not allow any liquids to enter into the
printer!
– Repairs to the printer may only be perfor-
med by authorized specialists who are
aware of the risks involved!
– Lay the power supply cable, data cables
and compressed air hoses (if applicable)
in a way that nobody can stumble over it.
– In case of emergency, switch off the printer
and disconnect the power supply cable!
– Only use original accessories!
Protection against injuries by
electrical current
– Only operate the printer using the system
voltage indicated on the nameplate!
– Only connect the printer to a grounded
power socket fitted to authorized stan-
dards!
– Connect only devices to the interfaces at
the printer that fulfil SELV (safety extra-low
voltage) circuit requirements according to
EN 60950!
Protection against injuries by
mechanical action
– Only operate the printer when the cover is
closed!
– Don´t wear loose long hair (if necessary,
wear a hairnet).
7
Publicité
Table des Matières
