Chef'sChoice D203 Manuel D'instructions page 4

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

DESCRIPTION OF THE CHEF'SCHOICE DIAMOND HONE® ULTRA
KNIFE SHARPENER MODEL D203
This advanced Diamond Hone Sharpener has two motor driven sharpening Stages 1 and 2,
followed by a single manual honing and polishing in Stage 3.
In Stage 1, motor-driven, highly effective diamond abrasive disks remove the dull edge
and create a sharp fully faceted edge at the conventional 20 degrees on each side of
the blade. In Stage 2 similar technology is used with finer diamond abrasives at a slightly
larger angle to create a small second bevel along the edge. This two step sharpening
and honing process leaves a stronger – arch shaped profile along the edge for greater
strength and durability. In Stage 3 the edge is lightly honed and polished to create a razor
sharp Trizor edge of increased perfection, sharpness and durability.
In Stage 1 there are two knife-guiding slots. These are referred to as the left and right
slots of Stage 1. Likewise in Stage 2 there are two guiding slots, left and right that sharpen
alternately the right and left side of the blade's edge. Stage 3 has only one guiding
slot that centers the blade in a manner so that both sides of the edge are honed
simultaneously. When sharpening in Stages 1 and 2, always follow an alternating pattern
of sharpening in the right and left slots. This pattern insures that both sides (facets) of the
edge are sharpened alike for better control of the cutting action of blade.
This three stage design provides the ultimate in versatility of the knife edge so that you
can tailor the edge geometry to your cutting needs. You will find that the Model D203
gives you a very sharp edge and one that remains significant bite for some of the more
difficult cutting tasks.
USING THE MODEL D203 SHARPENER
Note: Always clean your knife before sharpening in the sharpener! For your safety, keep
your fingers clear of the blade edge at all times.
You will find that the sharpener can create and maintain a very sharp and effective edge
on all your conventional fine edge and serrated cutlery. The primary edge facets are each
formed in Stage 1 at a nominal 20 degrees on each side of the edge, which results in a
total primary edge of 40 degrees. Stages 2 and 3 create a second and third bevel at
slightly larger angles leaving a strong triple beveled edge structure. Always use the
sharpener with the stage numbers 1, 2 and 3 facing you.
STAGE 1
To sharpen, place the sharpener on the table gripping it securely with your left hand. Push
on the power switch. Insert the knife blade, (Figure 1) near its handle, into the far left slot
Figure 1. Inserting the blade in the left slot of the
Stage 1. Alternate individual pulls in left and
right slots.
Figure 2. Inserting the blade in the right slot of
Stage 1. Alternate pulls in left and right slots.
English — 4

Publicité

Table des Matières
loading

Table des Matières