dosatron D3IL3000EX Manuel D'utilisation page 45

(see accessories), if a filter is not
installed abrasive substances will
cause the DOSATRON to deteriorate
prematurely.
3 - WATER-HAMMER / EXCESSIVE
FLOW
- For installations subject to water
hammer a protection device such
as a check valve or union ball check
must be fitted (pressure/flow control
system).
- For automatic installations, slow
opening and closing solenoid valves
are preferable.
- In an installation
DOSATRON serves several sectors,
the closing of one sector and the
opening of another sector must be
done at the same time (simultaneous
operation of the solenoid valves).
4 - INSTALLATION LOCATION
- The location of the DOSATRON
and concentrate container should be
accessible, but should never present
a risk of pollution or contamination.
- It is recommended to label all
water lines with a warning about the
injected solution i.e.
IMPORTANT ! Not For Human
Consumption.
5 - MAINTENANCE
- Rinse the injection areas after using
the DOSATRON. To do this, insert
where a
©
DOSATRON INTERNATIONAL S.A.S / 45
suction tube into a container of clean
water and inject about 1/4 liter [8 1/2
US Fl.oz].
- Routine inspection once a year,
and appropriate maintenance by the
Dosatron approved distributor when
required.
6 - SERVICE
Your dispenser
1 equipment.
traceability must be preserved all
along the product life (manufacturing
and maintenance). Thus, in case a
maintenance is required, the unit
must be sent back to the Dosatron
approved distributor who provided it.
is a category
Therefore, the