Operation; Cleaning Your Teeth With The Brush Head - Nevadent NSZB 3.7 B3 Mode D'emploi

All manuals and user guides at all-guides.com

Operation

This toothbrush has 3 different power levels:
–
"Clean": normal speed, orange "Clean" LED 9
For cleaning the teeth .
–
"Soft": slow speed, green "Soft" LED 8
For cleaning the teeth of people with sensitive gums .
–
"Pulse": slow speed with short breaks, yellow "Pulse" LED 7
For massaging the gums .
■ Press the on/off switch 0 once to activate the "Clean" mode . The "Clean"
LED 9 lights up .
■ Press once more to switch to "Soft" mode . The "Soft" LED 8 lights up .
■ Press it a third time to switch to "Pulse" mode . The "Pulse" LED 7 lights up .
■ To switch the toothbrush off, press the on/off switch 0 once more .
NOTE
If you operate one of the modes for longer than 10 seconds and then
press the On/Off switch 0, the toothbrush will switch off .
Next time you switch it on, the toothbrush will automatically start in the
mode you were using last .
To change the mode again, press the On/Off switch 0 repeatedly until
the appliance switches to the required mode as described above .

Cleaning your teeth with the brush head

WARNING!
The unfamiliar stimulation may cause light gum bleeding at first . This is normal .
If this continues for more than two weeks, you should consult your dentist .
1) Place the brush head 1 on the handset .
2) Moisten the brush under flowing water .
3) Put a little toothpaste onto the wet brush .
NOTE
To avoid being sprayed, do not switch on the appliance until it is in your
mouth .
4) Use the on/off switch 0 to select the desired operating mode .
NOTE
This toothbrush has a 30-second interval timer, so that all four jaw quadrants
can be cleaned evenly .
5) Divide your mouth into four parts (quadrants): upper left, upper right,
lower left and lower right .
NSZB 3.7 B3 GB │ IE │ 17 ■