Operation; Brushing Teeth - Nevadent NSZD 3.7 A1 Mode D'emploi

Operation

This toothbrush has 4 different power levels:
–
"White": high speed level, orange
For especially thorough cleaning of the teeth.
–
"Clean": normal speed level, green
For cleaning the teeth.
–
"Soft": slow speed level, yellow
For cleaning the teeth if you have sensitive gums.
–
"Pulse": low speed level with short breaks, red
For massaging the gums.
■ Press the On/Off switch
The "White" LED
■ Press once more to switch to "Clean" mode.
The "Clean" LED
■ Press it a third time to switch to "Soft" mode.
The "Soft" LED
■ Press it a fourth time to switch to "Pulse" mode.
The "Pulse" LED
■ To switch the toothbrush off, press the On/Off switch
NOTE
If you operate one of the modes for longer than 10 seconds and then press
the On/Off switch
Next time you switch it on, the toothbrush will automatically start in the mode
you were using last.
To change the mode again, press the On/Off switch
appliance switches to the required mode as described above.

Brushing Teeth

WARNING!
The unfamiliar stimulation may cause light gum bleeding at first. This is normal.
If this continues for more than two weeks, you should consult your dentist.
1) Place the brush head
2) Moisten the brush under flowing water.
3) Put a little toothpaste onto the wet brush.
NOTE
To avoid being sprayed, do not switch on the appliance until it is in your
mouth.
4) Use the on/off switch
NOTE
This toothbrush has a 30-second interval timer, so that all four jaw quadrants
can be cleaned evenly.
5) Divide your mouth into four parts (quadrants): upper left, upper right,
lower left and lower right.
NSZD 3.7 A1
once to activate the "White" mode.
illuminates.
lights up.
lights up.
lights up.
, the toothbrush will switch off.
on the handset.
to select the desired operating mode.
"White" LED
"Clean" LED
"Soft" LED
"Pulse" LED
once more.
repeatedly until the
GB │ IE │ 15 ■