5) Allow the handset to charge up for around
14 - 16 hours before using it for the first
time. The charge indicator
the hand appliance lights up red during the
charging process.
6) Use the handset repeatedly without charging
the battery until the performance becomes
noticeably weaker or the toothbrush stops
working and the charge indicator
Then recharge the battery for 14 - 16 hours.
When the appliance is fully charged, the
charge indicator
7) Charge and discharge the toothbrush com-
pletely 3 times. The battery will have then
reached its full capacity.
8) You can now leave the handset in the char-
ger
after every use, so as to always have
full power available.
Fitting/removing brush heads
■
To remove the brush head
and then pull it upwards.
■
To fit the brush head
offset on the hand element and then turn it
anti-clockwise.
NOTE
To avoid damage to the appliance, always use
original brush heads.
(For replacement brush heads, see the order
card)
NAZ 2.4 B2
on the front of
blinks red.
lights up green.
, turn it clockwise
place it slightly
Operation
This toothbrush has 3 different performing levels:
–
"Clean": normal speed,
orange "Clean" LED
For cleaning the teeth.
–
"Soft": slow speed, green "Soft" LED
For cleaning the teeth of people with
sensitive gums.
–
"Pulse": alternating speeds,
yellow "Pulse" LED
For massaging the gums.
■
Press the on/off switch
"Clean" mode. The "Clean" LED
■
Press once more to switch to "Soft" mode.
The "Soft" LED
lights up.
■
Press it a third time to switch to "Pulse" mode.
The "Pulse" LED
■
To switch the toothbrush off, press the on/off
switch
once more.
Brushing teeth
WARNING!
Due to the unaccustomed effect of the tooth-
brush, there may be some initial gum bleeding,
this is normal. If this continues for more than two
weeks, you should consult your dentist.
1) Place the brush head
2) Moisten the brush under flowing water.
3) Put a little toothpaste onto the wet brush.
.
.
once to activate the
lights up.
lights up.
on the handset.
GB │ IE
│
5
.
■