Fitting/Removing Brush Heads; Operation; Brushing Teeth - Nevadent NAZ 2.4 A1 Mode D'emploi

Fitting/removing brush heads

To remove the brush head 2, turn it clockwise
■
and then pull it upwards.
To fi t the brush head 2 place it slightly off set
■
on the hand element and then turn it anti-
clockwise.
NOTE
To avoid damage to the appliance, always use
original brush heads.
(For replacement brush heads, see the order
card)

Operation

This toothbrush has 3 diff erent performing levels:
–
"Clean": normal speed,
orange "Clean" LED 4.
For cleaning the teeth.
–
"Soft": slow speed, green "Soft" LED 5.
For cleaning the teeth of people with
sensitive gums.
–
"Pulse": alternating speeds,
yellow "Pulse" LED 6.
For massaging the gums.
Press the on/off switch 3 once to activate the
■
"Clean" mode. The "Clean" LED 4 lights up.
■ Press once more to switch to "Soft" mode.
The "Soft" LED 5 lights up.
■ Press it a third time to switch to "Pulse" mode.
The "Pulse" LED 6 lights up.
■ To switch the toothbrush off , press the on/off
switch 3 once more.
NAZ 2.4 A1

Brushing teeth

WARNING!
Due to the unaccustomed eff ect of the tooth-
brush, there may be some initial gum bleeding.
This is normal. If this continues for more than
two weeks, you should consult your dentist.
1) Place the brush head 2 on the handset.
2) Moisten the brush under fl owing water.
3) Put a little toothpaste onto the wet brush.
NOTE
To avoid spray, do not switch on the appliance
until it is in your mouth
4) Use the on/off switch 3 to select the desired
operating mode.
NOTE
This toothbrush has a 30-second interval timer,
so that all four jaw quadrants can be cleaned
evenly.
5) Divide your mouth into four parts (quadrants):
upper left, upper right, lower left and lower
right.
GB
IE
5