First Use; Fitting / Removing Brush Heads; Operation - Nevadent DAZD 3.7 Li B1 Mode D'emploi

First use

NOTE
Before starting to use the appliance, check that
it is in fault-free condition. If it is not, it must not
be used.
1) Insert the plug into the mains power socket.
2) Before initial use, clean the new brush heads
with fresh water.
3) Open the lid of the charger
the replacement brush heads on the brush
holders. Re-close the lid
4) Place the handset on the charger
it slides onto the pin on the base.
5) Allow the handset to charge up for around
14 - 16 hours before using it for the first
time. The charge indicator
the hand appliance lights up red during the
charging process.
6) Use the handset repeatedly without charging
the battery until the performance becomes
noticeably weaker or the toothbrush stops
working and the charge indicator
Then recharge the battery for 14 - 16 hours.
When the appliance is fully charged, the
charge indicator
7) Charge and discharge the toothbrush com-
pletely 3 times. The battery will have then
reached its full capacity.
8) You can now leave the handset in the char-
ger after every use, so as to always have
full power available.
DAZD 3.7 Li B1
and place
.
so that
on the front of
blinks red.
lights up green.

Fitting / removing brush heads

■ To remove the brush head
and then pull it upwards.
■ To fit the brush head
on the hand element and then turn it anti-
clockwise.
NOTE
To avoid damage to the appliance, always use
original brush heads.
(For replacement brush heads, see the order
card)

Operation

This toothbrush has 3 different performing levels:
–
"Clean": normal speed,
orange "Clean" LED
For cleaning the teeth.
–
"Soft": slow speed,
green "Soft" LED
For cleaning the teeth of people with
sensitive gums.
–
"Pulse": alternating speeds,
yellow "Pulse" LED
For massaging the gums.
■ Press the on/off switch
"Clean" mode. The "Clean" LED
■ Press once more to switch to "Soft" mode.
The "Soft" LED lights up.
■ Press it a third time to switch to "Pulse" mode.
The "Pulse" LED
■ To switch the toothbrush off, press the on/off
switch once more.
, turn it clockwise
place it slightly offset
once to activate the
lights up.
lights up.
GB │ IE │
5 ■