gourmetmaxx Z 02110 Mode D'emploi page 23

■ If the stirring paddle stops turning while the device is in operation, switch off the device
and remove the stirring paddle as otherwise it may become frozen solid in the ice
cream.
■ The device has an overload protection function. If the motor gets too hot during use,
the device switches off automatically. In this case, you should pull the mains plug
out of the socket, remove the stirring paddle from the inner container as otherwise
it could become frozen solid in the ice cream, and allow the device to cool down
completely before you use it again.
■ If the stirring paddle needs to be removed during use, use a spoon or similar
implement to remove the ice cream. Do not use the outlet unit!
1. Place the base on a dry, even, and fi rm surface. Make sure you follow the notes on
set-up and connection in the "Safety Instructions" chapter.
23
2. Place the outer container on the base and slide the
container down as far as possible (see picture).
3. Place the ring holder on a dry, fl at surface that is not
sensitive to the cold.
4. Remove the inner container from the freezer and place it
into the ring holder.
5. Lift up the ring holder and the inner container and
place both of them into the outer container. Make sure
that the ring holder is seated correctly in the outer
container.
6. Place the motor unit onto the lid. Make sure that the
catches on the motor unit (A) lock correctly in the lid.
To remove the motor unit, press both catches together
and lift the motor unit off the lid.
EN