How To Use The Device; Residual Heat - Steba IK 650 Slim Mode D'emploi

How to use the device

∙ Plug the device into an earthed socket.
∙ A signal tone sounds, the display is illuminated. The device is in stand-by mode.
∙ Place the induction suited cookware with a min. diameter of 12cm on the plate.
∙ Press the on/off
∙ Chose temperature or power with the select button
∙ The temperature can be adjusted with the +/- button in steps of 60 – 80 – 120 – 150
– 180 – 200 – 220 – 240°C. The power can be adjusted in steps of:
∙ right plate: 400 - 600 - 800 - 1000 - 1100 - 1200 - 1300 - 1400 watts
∙ left plate: 300 - 700 - 1000 - 1200 - 1400 - 1600 1800 - 2000 watts
∙ The device starts.
∙ During operation, the temperature or power can be changed.
Timer
∙ If the temperature or power is set and no amendments are made, the device turns
off automatically after 2:59 hours.
∙ Press the timer button
back to normal operation.
∙ Max timer setting is 2 hours 59 minutes
∙ Set the hours with the
∙ Set the minutes with the
∙ The time is accepted within 5 seconds and the time begins to count down.
∙ The display shows time and temperature in change.
∙ The time can be changed by pressing the timer button and the +/- buttons.
∙ After the time run out a signal tone sounds and the device switches automatically
into the stand-by mode.

Residual heat

∙ After turning off the device the display shows:
H the temperature of the plate is above 60°C
∙ The ventilation of the device runs for a couple of minutes after the device has been
turn off. Unplug after the ventilation shuts off.
12
button. The display shows "ON".
. The display shows "0000", after 5 seconds the device gets
button.
button.
.