Working Instructions - Würth MSF 40 Traduction Des Instructions De Service D'origine

Attaching dust extraction
Risk of harm to health.
Dusts can be harmful to health.
Â
Never work without dust extraction!
¾
Risk of harm to health.
Motor can clog with masonry dust.
Â
Never work without dust extraction!
¾
▸
Use a suitable Würth vacuum cleaner.
▸
Only use anti-static or electrically conducting
suction hoses and connection sleeves.
Operation
WARNING!
Risk of severe injuries.
Always guide the machine with both
¾
hands.
First switch on, then bring the
¾
attachment into contact with the
workpiece.
WARNING!
Danger of unintentional starting
Always switch off the machine when
¾
the mains plug is removed from the
plug socket or if a power failure has
occurred.
WARNING!
Risk of severe injuries.
If the machine is set to continuous run-
Â
ning, it will continue to run if it is torn
out of your hand.
Always hold the machine with both
¾
hands at the handles provided, take
up a stable posture and concentrate
on the work in hand.
22
All manuals and user guides at all-guides.com
CAUTION!
CAUTION!
WARNING!
Risk of severe injuries.
Take care to prevent the machine
¾
from drawing in or stirring up dust
and chips.
After switching off the machine,
¾
wait until the motor has come to a
standstill before you place it down.
Non-continuous operation
Switch ON
▸
Push the locking device [2] in the direction of the
arrow
▸
Press the trigger switch [3].
Switch OFF
▸
Release trigger switch [3].
Continuous operation
Switch ON
▸
Push the locking device [2] in the direction of the
arrow
▸
Press and hold the trigger switch [3].
The machine is switched on.
3
▸
Press locking device [2] again in the direction of
the arrow, to lock the trigger switch [3].
Switch OFF
▸
Press and release the trigger switch [3].

Working instructions

Note
Always control the machine with both
hands on the handles [8] und [5].
There are markings [7] on the protective guard.
The markings are an extension of the rear diamond
cut-off wheel and serve, when cutting slots, as a cut
indicator.
▸
Place the wall chaser (with switched on motor)
with the front support wheels 12 on the surface in
which the slot is to be cut and slowly swivel down
until the set cutting depth is reached.
▸
Push the machine in the cutting direction.
Note
Always push the machine in the pre-
scribed direction through the material be-
ing cut! See arrow [11] on the protective
guard. Otherwise the wheel may snag,
spring out of the workpiece or kickback.
▸
Once the slot is complete, switch off the device
and hold still until the diamond cut-off wheel has
come to a stop.