Further Safety Instructions - Würth MSF 40 Traduction Des Instructions De Service D'origine

Do not attach a saw chain wood-
e)
carving blade, toothed saw blade or
segmented diamond disk with more
than 10 mm wide slits. Such accessories
frequently cause kickback or loss of control over
the electric tool.
Avoid blocking of the cut-off wheel
f)
or excessive contact pressure. Do not
make excessively deep cuts. Overloading
of the cut-off wheel increases the pressure and
the susceptibility to tilting or blocking, and hence
the risk of kickback or grinding wheel breakage.
If the cut-off wheel jams or you inter-
g)
rupt the work, switch off the device and
hold it steady until the wheel has come
to a standstill. Never try to pull the run-
ning cut-off wheel out of the cut as this
could result in a recoil. Identify and remedy
the cause of the jamming.
Do not switch on the electric tool again
h)
as long as it is in the workpiece. Allow
the cut-off wheel to reach its full speed
before carefully continuing the cut.
Otherwise the wheel may snag, spring out of the
workpiece or kickback.
Risk of severe injuries.
The wheel may snag, spring out of
Â
the workpiece or cause kickback.
Always wear protective goggles.
¾
Always push the machine in the
¾
prescribed direction through the
material being cut (see [11] on the
protective guard).
18
All manuals and user guides at all-guides.com
Special safety instructions

Further safety instructions

WARNING!
Support plates or large workpieces to
i)
reduce the risk of a recoil caused by the
cut-off wheel jamming. Large workpieces
can bend under their own weight. The workpiece
must be supported on both sides of the wheel,
both in the vicinity of the cut and at the edge.
Be particularly careful when cutting
j)
"pockets" in existing walls or other sur-
faces that you cannot see behind. As the
wheel cuts into the surface it may collide with gas
or water pipes, electric cables or other objects
and cause kickback.
▸
Do not use any composite cut-off
wheels or roughing discs. Only use
diamond cut-off wheels.
▸
Materials which emit health-endan-
gering dusts or vapours during cutting
must not be cut.
▸
Generally recognised accident pre-
vention regulations and the enclosed
safety instructions must be observed.
▸
Check that at the point where work is to be per-
formed, there are no power, water or gas lines
(e.g. using a metal detector).
▸
The workpiece must be resting on a stable sur-
face and secured to prevent slipping, e.g. using
clamping devices. Large workpieces must be
adequately supported.