Abicor Binzel iSTM Mode D'emploi page 37

iSTM
9.1 Cleaning the iSTM ABIROB
1 Cover ring
2 2 set screws
Fig. 11 Cleaning the iSTM ABIROB
®
A torch neck
1
3 iSTM ABIROB
®
A torch neck
WARNING
Risk of injury
Serious injuries caused by parts swirling around.
• When cleaning with compressed air, wear suitable protective clothing, in
particular safety goggles.
1 Clean the iSTM ABIROB
2 Turn the cover ring (1) to the right until the stop and remove it.
3 Check the O-ring (4) for wear and replace it if necessary.
4 Clean the bores of the set screws (2) with compressed air.
5 Check the set screws (2) for wear and replace them if necessary.
6 Grease the O-rings (4) with sealing grease (included in the scope of
delivery).
7 Mount set screws (2), O-ring (4) and cover ring (1).
9 Maintenance and cleaning
4
®
A 4
®
A (3) with compressed air.
2
3
O-ring
EN - 17