HOMCOM A90-196 Instructions D'assemblage page 4

• ALWAYS keep your pelvis positioned over the center line of the Folding Magnetic Exercise Cycle
stationary bike.
• NEVER adjust the resistance of the flywheel and the resistance of the Folding Magnetic Exercise
Cycle Handlebar System while standing.
• NEVER use accessory attachments that have not been recommended by the manufacturer - using
these attachments may cause injury or damage to the bike and will affect the warranty of the bike.
• Please ensure that the Folding Magnetic Exercise Cycle is wiped down after each use to keep it
sanitary. If any problems arise affecting the performance of the Folding Magnetic Exercise Cycle,
please contact the manufacturer immediately. Always ensure that parts which undergo wear are
checked regularly.
• THIS SAFETY INFORMATION AND USER'S MANUAL DOES NOT REPLACE THE NEED TO BE
ALERT AND TO USE COMMON SENSE WHEN USING THE STATIONARY BIKE!
• For household, consumer use only.
• It is recommended to have a minimum clearance of 0.6 m (23.7 in) on at least one side and 0.6 m
(23.7 in) in front and behind exercise bike for easy access to, passage around, and emergency
dismount.
• The product unit weight saround 19kg and the dimensions is around 1100 x 530 x 1150 mm.
• This stationary training equipment is not suitable for high accuracy purposes.
Do not mix old and new batteries.
Do not mix alkaline, standard (carbon-zinc), or rechargeable (Ni-Cd, Ni-MH, etc) batteries.
Please note that changes or modifications not expressly approved by the party responsible for compliance could
void the user's authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to
Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference
in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.