Presetting Stations; Manual Presetting; To Change The Fm Reception Mode - JVC VS-DT2000 Manuel D'instructions

Using the Tuner

Presetting Stations

(Using the Remote Control)
You can preset up to 30 FM stations and up to 15 AM sta-
tions.
• Preset numbers may have been set to factory test fre-
quencies prior to shipment. This is not a malfunction. You
can preset the stations you want into memory by following
one of the presetting methods below.

Manual Presetting

FM/AM
When changing the
Band
1
Select a band by pressing the FM/AM
button.
Press the 4 or ¢ (
2
tune in a station.
3
Press the SET button.
"SET" will blink for 5 seconds.
Within 5 seconds, proceed to the next step.
When the display returns to the one set in step 2 after 5
seconds, press the SET button again.
4
Press the > or < button within 5 seconds
to select the preset number.
> or < button: Increase or decrease the preset
number by 1.
Pressing and holding the button will
rapidly increase or decrease the pre-
set number.
5
Press the SET button within 5 seconds.
"STORED" appears and after 2 seconds, the display re-
turns to the broadcast frequency display.
6
Repeat above steps 1 to 5 for each sta-
tion you want to store in memory with a
preset number.
To change the preset stations, repeat the same
steps as above.
CAUTION:
• Even if the system is unplugged or if the
power failure occurs, the preset stations
will be stored for about 24 hours. However,
in case the preset stations are erased, you
will need to preset the stations again.
17
SET STORED
SET SET
or
FM = 30, AM = 15
or ) button to
To Change the FM Reception
Mode
(Using the Remote Control)
When you are tuned into an FM stereo broadcast, the
"STEREO" indicator lights up and you can hear stereo ef-
fects.
If an FM stereo broadcast is hard to receive or noisy, you
can select Monaural mode. Reception improves, but you
lose stereo effect.
Press the FM MODE button on the Remote Control
so that the "MONO" indicator lights up on the dis-
play.
FM MODE
To restore the stereo effect, press the FM MODE but-
ton on the Remote Control so that the "MONO" indicator
goes off.
MONO