Input Terminals - JVC VS-DT2000 Manuel D'instructions

Using the Powered Subwoofer

INPUT Terminals

The Subwoofer has the following INPUT terminals.
INPUT(LOW-LEVEL):
Usually, the LEFT/MONO terminal is connected to the SUBWOOFER terminal of the Center Unit with the supplied signal
cord. (See page 7.)
When the Center Unit CA-VSDT2000 is not used (Using other equipment)
If an amplifier etc. to be connected does not have the SUB WOOFER OUT terminals, the RIGHT and LEFT/MONO ter-
minals will be connected to the LINE OUT-RIGHT and LEFT terminals of that unit.
Connecting cord
(not supplied)
INPUT (HIGH-LEVEL):
You can connect the speaker output terminals of other amplifier etc. to these terminals.
Connect the speaker cords in parallel to the speaker terminals on the amplifier etc.
• Do not use the INPUT (LOW-LEVEL) terminals and the INPUT (HIGH-LEVEL) terminals at the same time.
15
LINE OUT
RIGHT LEFT
SPEAKER
RIGHT LEFT
Speaker cords
(not supplied)
Amplifier etc.
Amplifier
etc.