Using The Tuner; Presetting Stations; Tuning In A Station - JVC FS-V30 Manuel D'instructions

Using the Tuner

REMOTE CONTROL RM-RXFSV5
DIMMER SLEEP POWER
DISPLAY FM MODE MD/AUX
AUTO
AHB PRO PRESET CD
PROGRAM RANDOM REPEAT
BASS TREBLE CANCEL
SET
UP
<
SET
DOWN
TUNER
TAPE CD
BAND
4
VOLUME
When the System is in use, the display shows other items as well.
For simplicity, only the items described in this section are shown here.
You can listen to FM and AM stations. Stations can be tuned in
manually, automatically, or from preset memory storage.
Before listening to the radio:
• Make sure that both the FM and AM antennas are correctly
connected. (See page 3.)
One touch radio ––––––––––––––––––––––
Just press the FM/AM button on the Unit (or the TUNER BAND
button on the Remote Control) to turn on the System and start
playing the station you were last tuned to.
You can switch from any other sound source to the radio by
pressing the FM/AM button on the Unit (or the TUNER BAND
button on the Remote Control).

Tuning In a Station

1 Press the FM/AM button on the Unit (or
the TUNER BAND button on the Remote
Control).
The band and frequency you were last tuned to appear on the
display.
(If the last station was selected using the preset number, the
preset number appears first.)
Each time you press the button, the band alternates between
FM and AM.
FM/AM
FM AM
(On the Unit)
2 Select a station using one of the
following methods.
Manual Tuning
Press the 4 or ¢ button repeatedly to move from
frequency to frequency until you find the station you want.
Auto Tuning
If you press and hold the 4 or ¢ button for one second or
more, the frequency changes down, or up, automatically until a
station is found.
8
STANDBY/ON
MD/
AUX
FM MODE
POWER
REC
AUTO PRESET
REV
MODE
PHONES
UP
>
DOWN
TUNER BAND
¢
TUNER
BAND
FM AM
(On the Remote Control)
OR
AHB
PRO
VOLUME
TIMER
CLOCK
CD
OPEN/CLOSE
TAPE FM/AM CD
FM/AM
DOWN MULTI CONTROL UP
¢
4
Band display, Frequency
display, Preset channel
Preset Tuning using the Remote Control (Possible
only after presetting stations)
Select the desired preset number using the UP, DOWN, > or <
button on the Remote Control. After 1 second the display will
show the preset number's band and frequency.
Example: Press the UP button until the preset number 12 "P-12"
appears.
UP or

Presetting Stations

You can preset up to 30 FM stations and up to 15 AM stations
using the Remote Control.
Note: Preset numbers may have been set to factory test
frequencies prior to shipment. This is not a malfunction.
You can preset the stations you want into memory by
following one of the presetting methods below.
Presetting stations manually ––––––––
TUNER
BAND
When changing the Band
1 Select a band by pressing the TUNER
BAND button.
2 Press the 4 or ¢ button to tune in a
station.
3 Press the SET button.
"SET" will flash for 5 seconds.
Within 5 seconds, proceed to the next step.
When the display returns to the one set in Step 2 after 5
seconds, press the SET button again.
FM mode indicators
MONO STEREO MONO STEREO
OR
DOWN
(After 1 second)
SET
UP
SET
or
DOWN
(Within 5 seconds)
FM = 30, AM = 15
STORED
SET