Getting Started; Accessories; How To Put Batteries In The Remote Control - JVC VS-DT2000 Manuel D'instructions

Getting Started

Accessories

Make sure that you have all of the following items, which are supplied with the System.
Power Cord (1)
AM Loop Antenna (1)
Remote Control (1)
Batteries (2)
FM Wire Antenna (1)
Signal Cord (1)
Spacers (4) (for SP-PW2000)
Stand (1) (for Center Unit)
Legs (2) (for Stand)
Screw (1) (for Stand)
Brackets (2) (for SP-VSDT2000)
Wing Bolts (2) (for SP-VSDT2000)
Paper Pattern (1)
If any of these items are missing, contact your dealer immediately.

How To Put Batteries In the Remote Control

Match the polarity (+ and –) on the batteries with the + and – markings in the battery compartment.
CAUTION:
• Handle batteries properly.
I To avoid battery leakage or explosion:
• Remove batteries when the Remote Control will not be used for a long time.
• When you need to replace the batteries, replace both batteries at the same time with new ones.
• Do not use an old battery with a new one.
• Do not use different types of batteries together.
3
R6P(SUM-3)/AA(15F)