Lubricating Plan - AL-KO solo R7-62.5 Mode D'emploi

GB
Activity
Check the tyre pressure
Check the mowing blades
Checking for loose parts
Checking V-belts (visual
check)
Cleaning the ride-on mower
Cleaning the air intake grille
on the engine
)*
Clean the transmission to re-
move grass and mowing res-
idues
)* Refer to the operating instructions of the en-
gine manufacturer
NOTE
It may be necessary to shorten the
maintenance intervals compared to
those stated in the table above in case
of severe loading and at high tempera-
tures.
9.2

Lubricating plan

To ensure that moving parts can move freely, we
recommend lubricating the following points at
least once a year.
Use a cloth to clean all points to be lubricated be-
fore greasing or spraying. Do not use water, so
as to avoid possible corrosion.
Lubrication points:
■
Spray oil onto the bearings of the front axle
on the frame.
■
Pivoting and bearing points: Lubricate all
movable pivoting and bearing points.
NOTE
The front and rear wheels must be re-
moved for greasing the axles and bear-
ings.
46
Before After
each use each use
X
X
X
X
X
X
After the Every 25
first 5 operating
hours hours
X
X
9.3 Cleaning the air filter (11, 25)
The air filter must be cleaned according to the
maintenance schedule. To remove the air filter
proceed as follows:
IMPORTANT!
Risk of property damage!
Engine components can be damaged
due to dirt ingress when cleaning the air
filter!
■
Make sure that the area surrounding
the air filter is clean and that no dirt
gets into the intake port of the en-
gine when the air filter is pulled off.
1. Switch off the engine and remove the ignition
key.
2. Wait until the engine has cooled down.
3. Fold the seat (11/1) forwards and open the
cover (11/2) to the engine compartment (11/
a).
4. Unscrew the mounting screw (25/1).
5. Pull the air filter cover (25/2) upwards off the
guide.
6. Pull the air filter (25/3) off the guide.
7. Clean the air filter or renew it if necessary.
8. Reinstall the air filter in reverse order and
tighten the mounting screw (25/1) again.
R7-62.5 | R7-63.8 A | R7-65.8 HD
Maintenance
Every 50 Each
operating time be-
hours fore put-
ting into
storage
X